There is no need to pull the fuse for this. Just hook the clip of the light up to a good ground and touch the two metal tabs on top of the fuse. Wal-Mart and any parts store will keep them in stock, usually at $10 or less. What works better is using a simple electrical test light to determine if the circuit works. You can pull it and visually inspect it to make sure that it is not broken.Įven if it looks fine, if you have another fuse of the same amperage, swap it anyway. It usually says something along the lines of “stop lamps” or stop. The first thing that you should do if all of the brake lights are not working is check the fuse. It is entirely possible that all the brake lights burned out at the same time. Please note that tail lights can work even if the brake lights are burned out. At some point the power is not getting from point A to point B. If none of the brake lights are working, we are going to follow the circuit from the fuse box back to the brake pedal. We’ll go into more depth on that below.ĭriving without the brake lights working is just as unsafe as if your Cherokee’s brake lights were stuck on. If even one of them comes on, you know that the brake light fuse isn’t blown. You should be able to see the brake lights illuminating the door. Just back up really close to the garage door and push the pedal. You can test whether or not your Cherokee’s brake lights are working all by yourself. The most common cause for this is a bad brake light switch. The good news is that troubleshooting brake lights that aren’t working isn’t too difficult. If your brake lights aren’t working, you’re way more likely to get rear ended than normal. They let other drivers know when you are slowing down, and that they need to slow down too. Brake lights are one of the most critical safety features that your Jeep Cherokee has.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |